Installing Resistors Led Tail Lights

The load resistor goes across the light bulb connections between the supply and ground.

Installing resistors led tail lights.

Alternately you can use cable ties to secure the resistors. This is your traction control basically what helps you when pulling off in rain snow. How to install load resistors for led turn signal lights. When finished the installation should look like this.

If you don t install load resistors also known as equalizers with led turn signal bulbs you will experience the notorious hyper flash issue. Now the question is what is hyper flash. To add a load resistor to an indicator turn signal it has to be wired into each led light bulb in parallel. You will need to do this for all of the led bulbs that blink with the blinkers or flashers and that illuminate brighter when the brake is applied.

You can experience the hyper flash problem with your led bulbs and this is the key reason for installing the loading resistance which is known as equalizer also. Some drivers have also mentioned that when this light is on their cruise control shuts off. Hyper flash is where the led light will flash continuously and rapidly. There have been many reports that after installing new led tail lights that the driver may see a tcl off light appear on their dashboard.

Avoid using electric tape as the tape will soften from the heat of the resistor. Why are installing load resistors necessary for led turn signal lights. To do this correctly you will need to wire the load resistor on the positive wire and then either ground it to the ground wire of the bulb or to a good frame ground. Secure resistors in place 3 led load resistor led bulb power wire quick connect ground wire.