Installing Chain Link Fence Tension Wire

It secures the bottom and top of your chain link fence to ensure the chain links remain tight to the posts and rails.

Installing chain link fence tension wire.

Tension wire should run along the same side of the posts as the fabric. Next measure the total length of the fence and mark where each terminal post will go. Tension wire generally is installed after the poles are set for a new chain link fence and before the fence installation. To install a chain link fence start by establishing your property lines and placing your post holes 4 inches inside those lines.

Installing a chain link fence can be easier with help. Top tension wire helps cut down on cost when used in lieu of top rail. The ears of the band pointed to the other terminal post. Tension wire is an important part of chain link fencing.

It is frequently used with vinyl coated chain link as this tends to be more elastic in nature. Tension wire may be installed at the top and or bottom of a chain link fence. Installing tension wire optional figure 12 wrap tension wire once around bottom rail end band carriage bolt. Adding tension wire to a chain link fence provides stability and security from dogs or people who try to go under a fence.

You ll want to dig your terminal posts first and then install your line posts. Make sure it s close enough to be fastened to the tension bands on the end post nearest the fence puller. The wire holds the chain link in place low to the ground very tightly so that it cannot bend at the bottom. We have created this how to guide to teach you the properly install tension wire for fences.

By mastering this lesson you will be a. Apply tension wire clips no more than 24 apart or as needed for securing the wire to the chain link fabric. Wrap the tension wire around itself with tightly wound loops at least four times. Install an end band at the base of the terminal post.

Using pliers twist several times to secure fig. Bottom wire helps deter animals from digging and pushing the bottom of the fabric out. If the mesh changed height or became distorted during tightening pull on it to reshape it.