Installing Bathroom Sink Water Supply Lines

They don t have to be exact just close.

Installing bathroom sink water supply lines.

If it is not then you will be able to simply cut off the main water supply to your home. The extra hoses that connect the faucet diverter to the sprayer or if the faucet is a widespread model to the handles are also usually 1 2 inch in diameter but they have proprietary quick connect fittings that vary by manufacturer. Shut off the water supply at the valve. You can either run these lines through the wall or up from the floor depending on the location of your bathroom.

Then flush and drain the tank. Installing water lines for bathroom sink. Step 2 remove old lines. Complete steps to replace bathroom sink water supply lines.

This video shows how to replace old bathroom water supply lines. You should however do a little preshaping of the soft copper before setting the sink into position in the countertop. If a bathroom faucet flexible water supply line or a rigid metal water supply line under a bathr. Coming in a variety of sizes and lengths this offers the most flexibility and makes installation a snap.

Step 1 turn off the water and drain the tank. Place the water line that s connected to the hot water pipe marked with red or some other color to the left control valve on the sink. Typically the shut off valve will be underneath the sink. The reason is because they can leak and create tons of water damage.

We specifically show how to swap out old supply lines at the toilet and sink faucet. A good replacement for this line is a stainless steel line. Pull the open ends of the water lines up to the base of the sink faucet. How to install a pex plumbing system how to replace a bathroom faucet replace bathroom sink supply lines how to install a pex plumbing system installing a bathroom sink wall hung how to install a bathroom sink 13.

Depending on the accessories that go with your faucet you may see other water supply line types under the sink. A hot and cold line for both the bathtub shower and the sink and a cold water line for the toilet. We ll discuss common leak points and show what water connectors make this super easy. The old supply line generally chrome tubing can corrode with age and begin to leak.

Measure the distance between the water supplies under the sink and then gently bend the soft copper supply tubes until they re about the same distance apart as the water supply. Install the water lines. You will need to get an open end wrench so that you will be able to successfully remove the supply line from the valve. Screw the nut on the water line onto the threaded connection that sticks out under the left control knob.

Turn on the water and check for leaks. Did you know bathroom water supply lines should be replaced every 10 years.