How To Put Logs In A Gas Fireplace

Learn how to install replacement logs in a gas fireplace from home improvement expert ron hazelton for more projects visit ron hazelton s website.

How to put logs in a gas fireplace.

Cover the entire fireplace floor area with lava rock which is usually included with the ceramic log kit. Put on some work gloves and remove the logs from the burner then dispose of them accordingly. Spread sand over the burner pan being careful to not cover and clog up the pilot. Make sure none of the logs is blocking the gas flow.

Disconnect the burner and gas line. Your grate is likely secured in place with screws so be sure to have a screwdriver on hand to remove those and then the grate. Place the largest ceramic logs on the bottom to serve as the foundation for the fire. Rearranging the logs doesn t change the amount of gas being let through the gas valve which is the only variable that will change how much heat the fireplace produces.

1 connect the gas line once your firebox is fully clean and the chimney has been professionally cleaned for wood burning fireplaces it s time to connect the gas line to your new burner. Connect the new log set s gas line to the burner. Applying pipe thread sealant around the gas line connection on the burner. If you have a remote start plug the receiver into the remote box.

Clean out your fireplace. Finally disconnect the old burner from the gas line and discard it. But sometimes the logs fall over or have other issues and need to be replaced or put back in position. Let s take a closer look at the three reasons you should never arrange your own ceramic gas fireplace logs.

The direction you lay them will depend on the design of the fireplace and the size of the logs. Remove the old log set. Install new gas logs. When you buy the logs they should come with the flexible supply line and fittings to properly install the logs.

It can however cause the unit to burn dirtier and create soot if you place the logs in a way that causes impingement flame touches them essentially. Fireplace safety avoid the silent killer. Make sure the gas line is properly attached to the gas burner. Begin by removing the old log set.

Put the rock wool over the sand and burner pan being careful to contain it to the area where you will be placing the ceramic logs later. You ll need pipe thread sealant adjustable wrenches and screwdrivers to set the logs. Shut off the gas before installing your gas logs.