How To Change A Hardwired Lamp To A Plug In

If it is only a two wire setup you can slide unstripped wires into a quick connect plug and clamp them in place.

How to change a hardwired lamp to a plug in.

I have a whole round up of great hardwired lights ranging from 25 50. Wrap wire around the screw. Cut a small v shape out of the bottom of your shape to allow the cord through. Then push the body of the plug down the wire and out of the way.

He told me the big end of the plug is black and the small end is white. Wrap the hooked wire around one of the screws on the inside of the plug and tighten the screw. All you need is a few supplies to. I plan on doing something similar with a hardwired light fixture that i have and this is exactly the direction i was looking for in how to execute that project.

I googled high and low looking for a plate similar to what you show since i feel like that is key to mounting and hiding the cord in the little gap of the plate that you mentioned. The female end is the plug in side where another plug is inserted. Repeat this process with the wire and screw on the other side of the plug. Using wire cutters cut both cords the one coming from the fixture and the one from the lamp cord 1 2 longer than you need them.

Attach a plug to the end of the lamp cord. If this is a three wire setup you will. Make sure the wires are lined up in the slot at the bottom of the plug. Some two wire extension cords have only a plastic coating and no sheathing.

Apply a silicone sealant along the back edges of your fixture. Tighten the screw to securely hold the wire. Your fixture may already have the wires separated which is fine. Even better the switch that would be controlling the light was on a 5 switch box so the whole box is grounded.

Plug in lights don t have grounds so would it even work. Cut the female plug off of the extension cord then cut about 4 inches of sheathing from the cord with the utility knife. Prepare your light fixture and gather your supplies. Remove the female end of the extension cord using wire cutters.

Line up your plastic shape on the back of your light fixture with the cord running out through your v and press it firmly into the silicone. Using your fingers pry apart your two wires 1 2 on both the fixture cord and the lamp cord. Undo the screw on the plug casing and open plug casing. Feed the light fixture s wires up through the base of the plug and out the front.

I decided to talk to my electrician and found out that most new plug in lights are self grounding. How to convert a hard wire light fixture into a plug in. Wind the wire in through the notch in the plug and snugly around the screw post.